there is a screw in each wheel well, if i remember right, the fasteners that hold the side skirt on along the car will have to be pried out, use a flat heat and pry out the center piece, then the fastener should come right off, do not try and pry out the whole fastener, just the little center piece, that will losen the barbs that are on it and it should come right off, i might of missed a few steps, but that is basically it, i scraped up my skirt and had to do the same thing, i found a deal though, 125 shipped for BOTH side skirts, painted, and to top it off, i only asked for one side, when i got it from ups, i had both, but i just got lucky
Where did you order the sideskirt from? I ran over a rock and it ripped mine If I were to search it on google, what am I searching for? When I look for 2008 Scion TC sideskirts, I come upon a lot of rice-y looking ones. I prefer the ones it came with but I don't know how to find it. Thanks in advance.
That's the lip from the OEM Ground Effects package. If you don't have the front/rear lip and other side skirt, it's going to look a little out of place.
If you want a good finish, have a shop paint it. Get several quotes before you do so.
Technically it's possible that you can get the same finish with a rattle-can. But you'd have to be very good at it. And even then the paint probably wouldn't match.
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.