Scion tC Forums banner
1 - 1 of 27 Posts

· Registered
372 Posts
Originally posted by TCrazy@Oct 4 2004, 06:47 PM
on most shifteres (at the base of the shifter) there is an allen set-screw. If you tighten down the shifter , then tighten this screw you should have no problems! - t
Hate to say it, but not on these.

A hint: try using teflon tape like on pipes. It should make it snugger. As always, if it starts getting to tight before it goes on all the way, don't force. Take it back off and figure out something else.

1 - 1 of 27 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.