Scion tC Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
I've installed s.tech on my car about 2 weeks ago. You will need the clamps to tighten down the top shock nut properly. I have maybe a little over 1/4in tread above each nut.

As far as the re-assembly (I'm doing this from memory so bear with me) I think you may have installed the bump stop upside down, this will cause the top mount not to slide down far enough. The foam part of the bump stop sould be facing down.

I noticed considerable drop in the rear, however the passanger side is a little over 1/4 inch higher than the driver side. If it doesnt settle in after a few more days i may pull them down again.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top